I send a couple of messages b4, but they were incomplete. These are my
problems:
I have a diamond stealth 3d 2000 2mb.I try to run nasrend without univbe,
and it says this:
Unable to initilize video (maybee no VESA driver?)
So i enabled univbe and it says this error now... can some1 send their
version of this file:
Rendition error desctiption: Failed to load SPD3D.UC
if some1 could send SPD3D.US to me it would be appreciated.
My other problem was with the paintkit:
1) i paint a car, and it looks good, but i have no shading on it, is there
a tool to do this, or is it just a manual thing?
2) can you get anti-aliasing for the decals u put on the car?
3) can you cut a bit off another car, and paste it onto yours? Like you
could do in NCR1
if possible, could you send all responses (and that SPD3D.UC) to my email
Regards,
Luke Phillips
This is the microcode file that is needed for the 3D accelerated
version which you can't run on your video card.
--
Emory University Graduate School of Arts & Sciences
Nascar Setups Page: http://userwww.service.emory.edu/~ebusch/
says...
you do not have a rendition video card. You can not use the rendition
files for nascar2
> My other problem was with the paintkit:
> 1) i paint a car, and it looks good, but i have no shading on it, is there
email
> Regards,
> Luke Phillips
--
http://www.netins.net/showcase/mpete
Nascar..Weather..Photo Gallery...OnNetCameras..Oddities..and more..
Stop on by, what can it hurt?
