I can't get my T2 pedals and CPR to work. Calibrates just fine no problems,
just can't get them to be seen I think. Do I need to customize controller
through CPR and tell it button # is brake and gas? I have a new computer
and didn't have any problems on my old one except it was too dang slow....
Steve
Reply via email preferred.
I have only run the CPR demo, and it's been a while, but if I recall you do
need to calibrate and set controls within the sim itself.
--
Don Burnette
I-65 Racing
Dburn on Ten
AOLL Iroc Series Administrator
http://pages.southtech.net/palmetto/aoll.htm
>I can't get my T2 pedals and CPR to work. Calibrates just fine no
problems,
>just can't get them to be seen I think. Do I need to customize controller
>through CPR and tell it button # is brake and gas? I have a new computer
>and didn't have any problems on my old one except it was too dang slow....
>Steve
>Reply via email preferred.
Never set any of the buttons for a gas or brake. Also, under win
calibration, did you use your custom version and had the special feature of
race car controler checked? If not, it has to be checked. Also, it is a 4
button, 2 axes wheeeel and peddle set, after that evrything should work
fine.
Mark F.
>I can't get my T2 pedals and CPR to work. Calibrates just fine no problems,
